GeneralChaos Posted September 14, 2017 Share Posted September 14, 2017 So I have an LNP with 4 LED strips on channel 1, and 4 fans on channel 2 (using a hub). Ideally, I'd like to use the the sequential channel effect, but when I set both channels to that, they seem to run independently of each other, and I end up with two separate sequential runs going. I have used the config to lay out the order of my fans and LED strips in my case, but that didn't seem to fix anything. Is there a way to have one single sequential channel effect going for both channels at once? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted September 15, 2017 Corsair Employee Share Posted September 15, 2017 There isn't currently a way to have a sequential effect going for both channels at once. Not currently. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.