bundito Posted September 25, 2019 Share Posted September 25, 2019 Hi. I'm trying to configure a brand-new system after my laptop kicked it yesterday morning. I have the combo of the K63 wireless keyboard with the lapboard, and a wireless Ironclaw to go with it. I've gotten the keyboard connected wirelessly with no problem (typing on it now), but the mouse will not link. I think I messed things up by plugging the mouse in with a USB cable... so now the system is "ignoring" the wireless pairing? Is there some way to revert that and start over? Also, isn't there some sync routine where you switch on the mouse to 2.4Ghz mode while holding one of the buttons? Or is that a different model? I'm confused, and frankly, the documentation stinks. Any help, fellow users? Thanks. Link to comment Share on other sites More sharing options...
Apophis3 Posted September 27, 2019 Share Posted September 27, 2019 1) Did you remember to grab the Ironclaw dongle from the dead system? (Just checking the obvious) 2) For 2.4 operation, make sure switch is all the way to the right. If it's wired, it can work in any position, and you may have it on off or BT mode. 3) With dongle installed, does it show IronClaw in iCUE? Link to comment Share on other sites More sharing options...
Recommended Posts