red-ray Posted August 13, 2015 Share Posted August 13, 2015 I have just updated to CL 3.2.5695 and noted as below: Only 1 of my 4 x CLCC were reported when 3.2.5676 reported 2 :mad:. All the devices connected to the CLCC are reported as being on Channel 1 so clearly is incorrect :(:. Is this a known bug and when will it be fixed? The H80iGT does not report the Available LED Channel when the H110iGT does. Is this a known bug and when will it be fixed? When I first ran CL it changed my H80iGT LED from RED to WHITE :(:, but my H110iGT LED stayed RED. Is this a known bug and when will it be fixed? My AX1500i has 3 temperature sensors, but CL only detected and reported 1 of them :sigh!:. My RM PSU fan is no longer flashing RED :D:, though CL incorrectly reports that it has a temperature sensor when it should be the +12V Current. Why is the 1.2.11 cooling node firmware (CorsairLinkCoolingFW_1.2.11.s19.gz) not shipped with CL :confused:? I can only control my H80iGT Fans, Pump and LEDs using the inbuilt sensor, but can use any sensor with my H110iGT. When will this be addressed? See http://forum.corsair.com/forums/showthread.php?p=795538. CL correctly ignored my NZXT Kraken :biggrin:. All my hardware must be working as SIV reports and controls it all (limited H80iGT control) :cool:. Other issues are as before and none have been addressed. See http://forum.corsair.com/forums/showthread.php?p=790530 :sigh!:. A good feature from my perspective is that CL 3.2.5695 reported so little of my hardware it took less time to recreate the profile :laughcry:. I realise my system is not typical :eek:, but given both HWiNFO and SIV can report it for CL not to is poor. I suspect this will never be addressed with CL3, but how much of it will CL4 report and when will it be released? My main questions are: Will it support one old Link Commander? What will be the upper limit of CLCCs supported? Will it support Cooling Nodes via a CLCC and how many? Will it support H80s and H100s via a CLCC and how many? Is there anything CL 3.2.5695 supports that CL4 will not? In general how many of each model of CL device will be supported? I know it has not been released, however the requirements specification should have answers to all of these questions. The devices I have and which were all detected and reported by SIV are as below. You will also see the worker thread usage is only 28% so SIV could easily support more :bigeyes:. What CL 3.2.5695 detected: What CL 3.2.5695 reported: What SIV reported: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.