paulh921 Posted June 27, 2012 Share Posted June 27, 2012 I have just installed M/B etc into new 500R. The front panel connectors are all working except:- Both front fans not working; The switch to on/off the LEDS on the fans not working; and The switch to vary the fan speed not working. The only connector I haven't plugged in is a black, male 4 pin header. I didn't know where it went but I have just learned from another post that it is the header for the side fan. So far didn't get as far as buttoning up the case! I just wondered if anyone else had a similar problem and how they solved it. Thanks, Paul Link to comment Share on other sites More sharing options...
G50EED Posted June 27, 2012 Share Posted June 27, 2012 The connector for the side panel fan is only a 3-pin connector. There is a 4-pin molex connector from the front panel fan controller that plugs into your PSU. Did you connect that? If not, there will not be any power to the fans. Link to comment Share on other sites More sharing options...
paulh921 Posted June 30, 2012 Author Share Posted June 30, 2012 Thanks G50EED. I hadn't properly fitted the molex plugs together. It was that simple. Thank you for taking the time to respond. Best regards, Paul Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.