Starkiller57 Posted December 6, 2018 Share Posted December 6, 2018 Hi, I have been using this keyboard since February and had no problem so far. But now I have a problem with the LED auto shutoff setting: I had set the keyboard so that the LEDs go out after 2 minutes to save power. Only after the firmware update, the keyboard goes into standby and must then reconnect again. Why was that changed? I thought "Enable LED auto shutoff" means the LED will go off automatically and not the whole keyboard. Can't you make two different options for these things? One for the LED auto shutoff and one for the standby mode. I hope the problem will be fixed soon. Link to comment Share on other sites More sharing options...
Apophis3 Posted December 6, 2018 Share Posted December 6, 2018 I think they added a KB Sleep feature to further improve battery savings. EDIT: Under Settings, there's an Enable Sleep Mode option. Link to comment Share on other sites More sharing options...
Starkiller57 Posted December 6, 2018 Author Share Posted December 6, 2018 Thank you for your reply Apophis, can you please show me where this function is? It does not exist In my program: Or is there any other settings I didn't find? Link to comment Share on other sites More sharing options...
Apophis3 Posted December 7, 2018 Share Posted December 7, 2018 I'm on firmware 3.19, and "Enable LED auto shutoff" is replaced by "Enable Sleep Mode" Link to comment Share on other sites More sharing options...
Starkiller57 Posted December 7, 2018 Author Share Posted December 7, 2018 Ok, thanks, iCUE tells me that the 3.10 is the latest version. But still good to know that they have renamed the function. Not the best solution but better than nothing. Link to comment Share on other sites More sharing options...
Recommended Posts