Kiunno Posted April 24, 2016 Share Posted April 24, 2016 Hi guys, Can anyone help me I'm currently fitting a H115i CPU cooler on to my new build. But the backplate screw hole nibs stick too far through the motherboard so when I screw in the standoff screws (that the pump assembly will screw onto with thumb screws), the whole thing is loose.:(: I'm thinking i could insert rubber washers between the backing plate and the back of the motherboard to pull it out slightly but can anyone concour? Link to comment Share on other sites More sharing options...
Corsair Employee Fauxbeard Posted April 25, 2016 Corsair Employee Share Posted April 25, 2016 Have a look at this. Link to comment Share on other sites More sharing options...
red-ray Posted April 25, 2016 Share Posted April 25, 2016 Have a look at this. The H115i, etc. are not listed so I guess this needs updating as does http://forum.corsair.com/forums/showthread.php?t=127331 Link to comment Share on other sites More sharing options...
Kiunno Posted April 25, 2016 Author Share Posted April 25, 2016 Have a look at this. Ah ok thanks for that, never saw that. It's done anyway i've modified it. Put a couple of washers and a rubber washer behind each hole. Thanks Fauxbeard and red-ray Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.