Pepelycan Posted April 11, 2016 Share Posted April 11, 2016 Hi every one. Last day i restore muy computer to the default settings, when i installed and try to open CL it froze my computer a little after the program interface show up. I did have CL before the restore, so i dont really know what is causing this. I use windows 10 x64, and muy corsair divice is a h110 gtx Link to comment Share on other sites More sharing options...
Sammydfp Posted April 12, 2016 Share Posted April 12, 2016 Hello Pepel I too am experiencing a similar fault with corsair link. In my case im using win7 home 64bit on the asrock 990fx extreme motherboard an all was working perfectly untill i reinstalled windows. After I reinstalled windows, and downloaded all the motherboard drivers for my board, I then downloaded corsair link and like always if its a new pc ur prompted to install .Net framework 4.5 - so i did that. The result is an instant bsod whenever I launch corsair link, regardless of the version of corsair link or the .net framework. This means that I can't use the application what so ever and is utterly broken atm. Now i know there is a current issue still with certain boards and their SATA in conjunction with the link software, but even if i delete the offending driver and launch link, it's still an instant bsod.. im inclined to think its the . Net framework at fault here. Any Help lads + lasses ? Link to comment Share on other sites More sharing options...
red-ray Posted April 12, 2016 Share Posted April 12, 2016 Any Help lads + lasses ? I would use WINDBG to analyse the dump file rather than just guessing what caused the BSOD. See http://forum.corsair.com/forums/showthread.php?p=760776 for how to do this. Even if it is CL I doubt Corsair will do much as I am still awaiting a response to http://forum.corsair.com/forums/showthread.php?p=845182 along with almost all the other issues I have posted about. Link to comment Share on other sites More sharing options...
Sammydfp Posted April 12, 2016 Share Posted April 12, 2016 I see, I thought a bout using the dump tool to identify it but I thought people would have more knowledge on here. As for link it's self, how can it of been working perfectly before hand and is dead now ? ( the computer reinstall was only a day ago ) On the worse end of the spectrum, is there something as good as or better than corsair link to monitor, auto change fan speeds at certain temps , ( links quiet mode , ballenced, and performance mode ) and the like. I've been looking at a few and none of them go as high speed rpm as links 2600 speed, the nearest is 2000-2200 which i would of thought would raise my temp horrible, as with link it's max temp was never over 60. ( would also need to be a 240mm rad to fit my case ) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.