Was thinking of another possible solution being to replace the front 3x LL fans included with the case to 3x 120mm ML rgb pro fans as the intake, keep the stock uncoloured ml fans that come with the radiator as pull. Then put the 3 LL fans that were at the front as top/rear exhaust (would MLs perform better at the top as exhaust because of it might needing more static pressure to push through the dust filter and case holes?).
Also heard that when doing a push pull config, having the front push fans as LL with the pull fans as ML, shouldnt make much of a difference vs having both push/pull fans as ML. Only time having LL fans would make a big difference is if I were to use them only as push from the front with no fans pulling. I know I'm over thinking this, but just want to get it right the first time and not waste more money than I have to.
Note, the LL fans push up to: 43.25 CFM and the ML fans up to 47.3 CFM.
Really torn atm. But again, I am leaning towards having the front mount radiator push/pull fans all ML (6 in total, front 3 rgb pros and inside 3 being the ones included with the rad) and the included LL case fans as exhaust.