xclock Posted February 15, 2015 Share Posted February 15, 2015 i had this problem with side perspex panel and now front air filter is bending outwardly. i just dont know what to do. will post the pix later. any solution.... i know the new front panel will replace that filter but still... Link to comment Share on other sites More sharing options...
Toasted Posted February 16, 2015 Share Posted February 16, 2015 Have you tried reinstalling the filter? Does it still bend outwards? You can also lay the filter flat on a table and see if it is bent. If it is, you can request an RMA to replace it. Make sure you upload a picture of your invoice as proof of purchase. Link to comment Share on other sites More sharing options...
xclock Posted February 16, 2015 Author Share Posted February 16, 2015 Have you tried reinstalling the filter? Does it still bend outwards? You can also lay the filter flat on a table and see if it is bent. If it is, you can request an RMA to replace it. Make sure you upload a picture of your invoice as proof of purchase. they did send side perspex panel. i think this is just a filter not a big deal but will see. i just wanted to put some heavy stuff on it just to straiten it. http://i59.tinypic.com/npl8wo.jpg Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted February 17, 2015 Corsair Employee Share Posted February 17, 2015 That filter is always going to flex some, it's just the nature of it. I wouldn't worry. Link to comment Share on other sites More sharing options...
RevolvingPrawn Posted February 17, 2015 Share Posted February 17, 2015 Is it bent similar to mine below? http://i1209.photobucket.com/albums/cc387/Bumfez/20150217_200353_zps96yidtqs.jpg It never sits flush if I just push it in with the clip at the top, so I made a quick vid to show you how I insert the filter to keep it on. Hope it helps! And even if it doesn't then at least the new front panel isn't far off :) [ame] [/ame] Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted February 18, 2015 Corsair Employee Share Posted February 18, 2015 That bow is normal, the dust filter is meant to be relatively flexible. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.