Jump to content
Corsair Community

Is my Memory defect?


ArmaGamer

Recommended Posts

Hy, I have bought for 3 weeks a completely new PC with Corsair XMS2 KIT 4096 MB PC2-6400U DDR2-800 CL5 DHX.

 

I have downloaded the program Memtest86 and wanted to test my 2 memories of Corsair, because I have recently received 2 strange error messages from Armed Assault Game. And now and again the system hang up during iam playing games.However, it seems seldom.

 

1: Cannot create system Memory Surface DXT5,1024x1024 (size1400832 B) Error Code8007000e

2: Cannot create system Memory Surface DXT5,2048x2048 (size5595136 B) Error Code8007000e

 

Therefore, I have inserted the Memtest CD or disk and have started, but after few seconds after the program start the picture gets stuck and freezes.

 

I have likewise already tested both memory modules individually and in the other slots, only with the success that with only one memory module (2 GB) the program any more does not freeze instead a new start caused.:mad:

 

Something wrong configurated?

 

Following a few pic´s, that i could made:

 

http://bestplacetobe.gmxhome.de/error/420.jpg

http://bestplacetobe.gmxhome.de/error/421.jpg

http://bestplacetobe.gmxhome.de/error/422.jpg

http://bestplacetobe.gmxhome.de/error/423.jpg

http://bestplacetobe.gmxhome.de/error/424.jpg

 

Tonight I will download the Memtest86+ and test what happen and after that i post it here.

 

My English is not very good, but maybe anyone can help me...Thx.

Link to comment
Share on other sites

  • Corsair Employees

With that MB you have to Disable legacy USB when running any memory test, and you need to be using http://www.memtest.org. In addition, you cannot run all 10 tests on that platform or it will do strange things and not give reliable results, that is in the read me file for Memtest. Just use the defaults tests.

 

Please make sure that you have the latest Bios version and then load setup/optimized defaults and set the Dim Voltage to 1.9 volts and then set the timings manually to the tested settings for the specific module you have, Cas 5-5-5-18, 2t Command Rate, and TRC 24 and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.

Link to comment
Share on other sites

Thanks for your fast good answer RAMGUY!

I have manually set the settings how you say. Isn´t the Vcc DIMM 1.8V?(you sad 1.9V)

Memtest86+ v1.7 is still runing till 8am without usb legacy support and no errors i hope....i will see todays afternoon. I have found out that the errors were shown from Arma not only my is problem. Other guys gotten that too. :D: Probably an Arma problem.

I will post conclusion about Memtest86+

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...