Pany Posted April 3, 2007 Share Posted April 3, 2007 Hello, and sorry but my english is not so good and I hope you can help me. I have two pairs CM2X1024-6400C4, and I can´t boot with 4GB, only with 2! Can you give me please the right settings for them? Give´s the Forum in german? Thank you! Best regards Richard Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 3, 2007 Corsair Employee Share Posted April 3, 2007 On any AM2 system you will need to operate the DDR frequency at 667MHZ if you have 4 modules installed. Link to comment Share on other sites More sharing options...
Pany Posted April 4, 2007 Author Share Posted April 4, 2007 Hi, really? I have it on Auto. Must I change this manualy to 667? Must I change Latency (I have 4-4-4-12) or Voltage (I have it on Auto) too? Thanks! Best regards Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 4, 2007 Corsair Employee Share Posted April 4, 2007 Amnually adjust the timings to 4-4-4-12@667MHZ Command rate 2T Link to comment Share on other sites More sharing options...
Pany Posted April 5, 2007 Author Share Posted April 5, 2007 Hi, also with this setting I have the same error. Thank you for help! Best regards Link to comment Share on other sites More sharing options...
Pany Posted April 8, 2007 Author Share Posted April 8, 2007 Hi, no solution? Please help me! Best regards Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 10, 2007 Corsair Employee Share Posted April 10, 2007 Set the following timings at 667MHZ: Sli ready: Disabled Memory Voltage: 2.0v TCL: 4 TRCD: 4 TRP: 4 TRAS: 12 Command RAte: 2T Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.