Koran Posted February 5, 2006 Share Posted February 5, 2006 I have a single VS1GBKIT677D2 RAM module and a MSI P4N Diamond. During memtest, i get Many errors, Starting as soon as i start the test. Should I just send it in or are there settings that could be configured wrong? Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted February 7, 2006 Corsair Employee Share Posted February 7, 2006 Please set the Dim Voltage to 2.1 volts and then set the timings manually to the tested settings for the specific module you have, and then test the module/modules one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. . Link to comment Share on other sites More sharing options...
Koran Posted February 13, 2006 Author Share Posted February 13, 2006 I put in the wrong RAM module #.....the correct one is VS1GB533D2 Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted February 14, 2006 Corsair Employee Share Posted February 14, 2006 Please try setting the memory voltage to 2.1 Volts after you load optimized defaults in your bios setup and then test with http://www.memtest.org to be sure. If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. . Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.