Jump to content
Corsair Community

New MB Locks UP


Recommended Posts

I was running an ASUS A8N-SLI with 4 CMX512 3200C2PT modules, two with version 5.1 and 2 with v2.2 & 4.2. The two latter versions were giving me some failures on this board, and the system would run faster once the two latter modules were removed.


I have now replaced the MB with an ASUS A8N32-SLI:D: , using the same modules from above, the system fails:mad: to boot. But after removing the v2.2 and v4.2 modules it boots fine:biggrin: . I put just the latter two modules in and still it will not boot, so I tried just one module according to there manual and the proper slots to use. And the board still fails to boot.


Is this a memory card failure:confused: and would these be covered under warrantee?


Thanks for your help.

Link to comment
Share on other sites

  • Corsair Employees

All of the modules would need to be the same part# and revision. But we can try replacing the older two modules if you like.


Please use the RMA request found in TSXpress or follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it!

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...