azalyn Posted January 2, 2006 Share Posted January 2, 2006 I bought a pair of TWINX CMX512-3200C2 Modules in september for a new system. I installed everything into my system according to instructions. When i booted the system it would get to the POST and reset and keep doing that. So, I simplified the system to hard drive, video card, and one stick of memory, Ran fine. Switched to other stick of memory on it's own. Failed. I would like to get the bad memory module replaced but i don't know where to begin. Azalyn Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted January 2, 2006 Corsair Employee Share Posted January 2, 2006 Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.