7000D/X GPU riser cable/front panel

[XxLaVaxX]

hi ,  on the Corsair 7000x / D full tower for the GPU riser cable .

whats a good pci-e 4.0  length cm to get ?   is there one point to mount or two places . 

also if possible how many outputs to the motherboard are from the front panel , so know if need any mb headers splitters/adapters for the mb am planning on

the only picture shows it rolled up on top and no diagram .manual pdf to that info. 

haven't got this case yet due to this issues to finalize possibility of obtaining

thanks for any input! 

Edited December 9, 2022 by XxLaVaxX

[LeDoyen]

For the front panel, have a look at the quick start guide from the product page :

https://www.corsair.com/corsairmedia/sys_master/productcontent/WW_7000D_7000D_Airflow_QSG_AA.pdf

Page 12, you have all the connexions

[XxLaVaxX]

thanks so much that does help with the front panel connectors/headers  alot .    

being will be using a ATX mb and the 1st pci-e GPU slot is almost always the same length from the cpu. I did a search (CORSAIR PCIe extension cable *sold separately*) as noted in the manual product pdf.  showing the riser cable.

seems only one offered by corsair in the search is 300mm which is 30cm and 11.81 inches which seem rather long.

guessing unless otherwise noted will have to with that rather safe then be too short. on a 70-80$(corsair msrp)Q4'22 part.

or if do end up getting wait and measure .will possibly report back the length needed.

where as another large brand case  enthoo pro 2 phaleks has a cage which riser cable is 220mm (22cm 8.6inches)

thanks.

Edited December 9, 2022 by XxLaVaxX