Jump to content
Corsair Community

Led Node Pro


snoopkills
 Share

Recommended Posts

Both my led nodes are not being picked up by the commander pro and the IQ software. The rgb strips that are plugged in seem to be on but just not being read by the software. I have them both fed into a commander pro. I recently did a mother board change out and for some reason the commander pro was not picked up at first. I had to restart a few times in order for the software to actually read the commander pro.
Link to comment
Share on other sites

  • Corsair Employees

Do you have the strips going directly to the LED channels on the Commander Pro or going through a Lighting Node PRO that is then connected to the Commander PRO?

Also, in iCUE, do you have those specific channels set to LED strips? You would choose what is being controlled per channel in iCUE.

Link to comment
Share on other sites

 Share

×
×
  • Create New...