Hayena Posted August 10, 2018 Share Posted August 10, 2018 Yesterday I've finally received my 500D RGB SE but during the installation of my motherboard I noticed the connectors on the back were off. The case came with plenty of screws but the installation guide is really lacking on... well installation. So with the case came a few rubbers which would allow me to raise the motherboard but none of the screws seem to be long enough to do this. Can anyone help me with this? Am I missing something? Link to comment Share on other sites More sharing options...
Corsair Employees Corsair StormShadow Posted August 10, 2018 Corsair Employees Share Posted August 10, 2018 Yesterday I've finally received my 500D RGB SE but during the installation of my motherboard I noticed the connectors on the back were off. The case came with plenty of screws but the installation guide is really lacking on... well installation. So with the case came a few rubbers which would allow me to raise the motherboard but none of the screws seem to be long enough to do this. Can anyone help me with this? Am I missing something? You're going to have to be more specific, or at least provide some visual, I'm not sure what you are talking about. Link to comment Share on other sites More sharing options...
Hayena Posted August 10, 2018 Author Share Posted August 10, 2018 Sorry if I was not clear in my original post, I hope these following pictures make my issue more clear. http://i68.tinypic.com/21nnomf.jpg As you can see the connectors and the backplate are not aligned properly http://i65.tinypic.com/105scr4.jpg These are the screws and rubbers provided with the case Link to comment Share on other sites More sharing options...
Krokarn Posted August 10, 2018 Share Posted August 10, 2018 Sorry if I was not clear in my original post, I hope these following pictures make my issue more clear. http://i65.tinypic.com/105scr4.jpg These are the screws and rubbers provided with the case Those screws and rubbers is not for the motherboard, they should be fitted in the two hdd-trays on the backside. What you can fit in the trays with those screws and rubbers do i not figured out yet. Link to comment Share on other sites More sharing options...
abhiv27 Posted November 18, 2018 Share Posted November 18, 2018 Those screws and rubbers is not for the motherboard, they should be fitted in the two hdd-trays on the backside. What you can fit in the trays with those screws and rubbers do i not figured out yet. can you tell me what those screws placed at upper left corner are for ? Link to comment Share on other sites More sharing options...
Recommended Posts