Draco Posted January 13, 2005 Share Posted January 13, 2005 I have bought 2 ValueSelect VS512MB400 Modules for my new pc using a AMD Athlon 64 3000+ on a Gigabyte K8NSNXP939 Motherboard. Running them in singlechannel mode works perfectly fine! Using dualchannel however, the system gets very instable :/ Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted January 13, 2005 Corsair Employee Share Posted January 13, 2005 Please make sure that you have the latest BIOS for your MB and load Setup/optimized default settings, and try the following BIOS settings; VS1GBKIT400 or VS512MB400 Advanced Chipset Features (Ctrl + F1) DRAM Clock: 400 MHz Configure Dram timing by SPD: Disabled/User define SDRAM CAS Latency: 2.5T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Row Precharge (tRP): 3T SDRAM Active to Precharge Delay (tRAS): 8T SDRAM Burst Length: 8 SDRAM Bank Interleave: 4/Auto/Enabled SDRAM Command Rate: 2T Frequency Voltage Control CPU Freq: 200 Memory or Dim Reference voltage: 2.7/2.75 Volts (+.2) AGP Voltage: Default *unless you have ATI 9200 or 9600 then 1.6 Volts suggested!* All other settings should be set to default settings! Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.