FarleyUK Posted December 8, 2004 Share Posted December 8, 2004 Hi all! I have 2 pairs of matched TwinX 3200XL memory (making 2 gig in total), but am not sure what the settings should be on this motherboard! I am running an AMD 64 3200+ CPU. Any help is appreciated! Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted December 8, 2004 Corsair Employee Share Posted December 8, 2004 With 4 modules I would suggest you set the timings to Cass 2.5-3-3-7 and set 2T command Rate to enabled with the Dim Voltage set to 2.8 Volts. Link to comment Share on other sites More sharing options...
FarleyUK Posted December 8, 2004 Author Share Posted December 8, 2004 With 4 modules I would suggest you set the timings to Cass 2.5-3-3-7 and set 2T command Rate to enabled with the Dim Voltage set to 2.8 Volts. OK, ta! But what do the numbers refer to in the BIOS settings? Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted December 8, 2004 Corsair Employee Share Posted December 8, 2004 Dim Voltage: 2.8 Volts CAS Latency CL=2.5 Row Cycle Time tRC Bios Default Row Refresh Cyc Time tRFC Bios Default Ras# to CAS# delay tRCD 3 Row to Row delay Bios Default Min Ras# Active Time tRAS 7 Row Precharge Time tRP 3 Write Recovery Time Bios Default Write to Read delay Bios Default Read to Write Delay Bios Default Refresh Period tREF Bios Default Enable 2T Timing Enabled Then test the system with http://www.memtest.org and make sure it's stable! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.