Lazerwolf Posted January 8, 2020 Share Posted January 8, 2020 Greetings! Does anyone know the pinout for the ML120 Pro or the ports on the RGB led fan hub? Thanks! Link to comment Share on other sites More sharing options...
DevBiker Posted January 8, 2020 Share Posted January 8, 2020 +5V / Data (From Fan) / Data (To Fan) / Ground Pin 1 is marked with an arrow. Link to comment Share on other sites More sharing options...
Lazerwolf Posted January 8, 2020 Author Share Posted January 8, 2020 Thank you!!! Link to comment Share on other sites More sharing options...
Lazerwolf Posted January 8, 2020 Author Share Posted January 8, 2020 (edited) My motherboard only has the 12v RGB header and as such it's unused. So, what I'm doing is wiring my addressable RGB section of my water cooling components to run off of the Corsair RGB led fan hub (I have the ML120 3-fan kit). In addition to the 5v and ground connections, I'm assuming I'll use the "data to fan" pin and the "from" fan will be unused? I guess I should first be asking if this will work? Thanks. Edited January 8, 2020 by Lazerwolf Link to comment Share on other sites More sharing options...
DevBiker Posted January 8, 2020 Share Posted January 8, 2020 Yes, it'll work. It'll have to be on the last position on the Fan Hub and configuration may be a challenge, depending on the number of LEDs that you have in your water cooling components. But it'll work. There are already adapters and such out there for this. But definitely kudos for DIY! Link to comment Share on other sites More sharing options...
Recommended Posts