Jump to content
Corsair Community

Pinout ML120Pro/Hub


Lazerwolf
 Share

Recommended Posts

My motherboard only has the 12v RGB header and as such it's unused. So, what I'm doing is wiring my addressable RGB section of my water cooling components to run off of the Corsair RGB led fan hub (I have the ML120 3-fan kit). In addition to the 5v and ground connections, I'm assuming I'll use the "data to fan" pin and the "from" fan will be unused? I guess I should first be asking if this will work? Thanks. Edited by Lazerwolf
Link to comment
Share on other sites

Yes, it'll work. It'll have to be on the last position on the Fan Hub and configuration may be a challenge, depending on the number of LEDs that you have in your water cooling components. But it'll work.

 

There are already adapters and such out there for this. But definitely kudos for DIY!

Link to comment
Share on other sites

 Share

×
×
  • Create New...