CptVelcro Posted December 11, 2018 Share Posted December 11, 2018 I was thinking about using an arduino as the input(Data into the hub) to give data to the hd 120's. I plan to run three of them and I hope to be able to power the rgb fans using the hub and data from an arduino. Any insight on if this would work and if so, how will it be setup? In addition could nzxt strips be plugged into the same hub? As they use 5 volt rgb strips. Link to comment Share on other sites More sharing options...
DevBiker Posted December 11, 2018 Share Posted December 11, 2018 Check this out: http://forum.corsair.com/v3/showthread.php?t=165029 Link to comment Share on other sites More sharing options...
solarity Posted December 11, 2018 Share Posted December 11, 2018 It will work and has been done by myself.and others. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.