Will it fit? 500D SE, 150i w/ 6 120 LL's in Push/Pull, 2080 Ti... will it fit?

Exactly the subject.

 

Exploring some build options before I pull the trigger. I'd like to run the 150i in a front mount setup with the 3 stock LL's the 500D SE comes with as well as 3 swapping out the 150i's stock fans for 3 more LL's in a push/pull config. I've been able to find a few setups like this that ran 1080 Ti. It appeared as though there was decent clearance without much issue.

 

The 2080 Ti is a beast of a card. I've done some "virtual" measurements but without having the hardware in my hands its hard to tell if the 2080 Ti will fit with this push/pull setup.

 

Does anyone have a similar setup? Or can anyone confirm if this config will fit?

 

Thanks for the feedback.

Certainly going to be 2080 Ti model dependent. There is quite a bit of variance in length and those triple fan cards are very long.

It should fit. I have that a similar and there's 3 inches to spare. My card is a dual fan model however. Odd angle but here's a pic:

 

It should fit. I have that a similar and there's 3 inches to spare. My card is a dual fan model however. Odd angle but here's a pic:

 

 

What fans are you running at the top and front? Are you using the top and rear as exhaust? If so, what are your CPU/GPU temps like on load?

Front are the stock LL, rest are ML 120's. Top and rear are exhaust. Temps are decent but I'm going to move the rad to the top of the case. I prefer it on the top as that allows a much better intake of air.