carman1tr Posted July 10, 2020 Share Posted July 10, 2020 Dear friends, I have a Corsair H100i RGB Platinium. It works fine. But The ML fans make a magnetic noise when they run at more than 800 rpm. Anyway, i bought 2xLL140 fans and installed to case. (They are not same size but i put fans at bottom and radiator on up the case.) The problem begins in this point. When i use the iCue the LED on the both pump and fans get very fast. Imagine the rainbow light effect is change the leds maybe 10 times faster than the normal effect. When i choose fans as ML, then some leds turn off. When i choose 1 LL fan it works good but just one fan's led works. When i turn off the iCue the leds work good. I uninstalled the iCue 2 times but no luck. I restarted the iCue several times but no luck. https://giphy.com/gifs/fsnrPoLEv2NaSBj5Ic Is the h100i Platinium really dont work with 2 LL fans? Do i need to get h100i Platinium SE? Or any alternative to make iCue work right? Or can i install Platinium SE firmware on my Platinium? Thank you. Link to comment Share on other sites More sharing options...
DevBiker Posted July 11, 2020 Share Posted July 11, 2020 You have to configure it as 2 LL fans and yes, it does work. However, that certainly doesn't look right. Do you have any other monitoring tools installed and/or running, particularly HWInfo? Link to comment Share on other sites More sharing options...
carman1tr Posted July 11, 2020 Author Share Posted July 11, 2020 i have Aida64 and Gigabyte Apps like RGB fusion. But when i close these programs the problem doesent finish. Link to comment Share on other sites More sharing options...
Recommended Posts