Franksi Posted October 1, 2019 Share Posted October 1, 2019 Hi Everyone, new to the forums here and after a little advice with helping to set up my partners sons case. He has the 220T and H100i Platinum RGB. Firstly, I’ll admit that I probably should have done a bit more research before ordering the parts for him! The original plan was to have the h100i in the roof of the case and 3 SP120 RGB PRO in the base front and one in the exhaust at the rear. The H100i is now going to go in the front, meaning I have 2x ML120 RGB on the cooler up front with 1 x SP120 RGB at the front and 3xSP120 RGB in the roof and rear. Here’s the problem - how do I get all of the fans under RGB control? I’ve subsequently discovered that you can’t run ML and SP fans on the same Lighting Node Core - does this mean I need to get a Commander Pro to control the H100i ML Fans and the AIO Block? Also, I only have 2 USB 2 headers on my Mobo so would that mean I plug the Lighting Node Core into one and the Commander Pro into the other and connect the H100i via the Commander Pro - both Fans and AIO Block? Hope it’s clear what I’m trying to achieve? We are trying to finish this up on Saturday so any advice would be appreciated! Thanks Franksi Link to comment Share on other sites More sharing options...
DevBiker Posted October 1, 2019 Share Posted October 1, 2019 The Platinum cooler has its own RGB control. Put the ML fans on there. Put the SP fans on the Lighting Node Core. All will be controllable from iCUE. Link to comment Share on other sites More sharing options...
krazykid Posted October 1, 2019 Share Posted October 1, 2019 Perhaps this can help with the building [ame] [/ame] Link to comment Share on other sites More sharing options...
Franksi Posted October 1, 2019 Author Share Posted October 1, 2019 Perhaps this can help with the building Thanks! I’ve gone with Vengeance RGB Memory so I think I’ll have to have my H100i in the front Link to comment Share on other sites More sharing options...
Recommended Posts