jrwininger Posted July 13, 2019 Share Posted July 13, 2019 Has anyone tried the PrimoChill RFB Rigid Tubing Finishing Bit with the 14mm Corsair tubing? It works for the most part, but seems to scuff the tubing. I'm wondering if the product I received is defective. Link to comment Share on other sites More sharing options...
Corsair Employee Corsair GregX Posted July 15, 2019 Corsair Employee Share Posted July 15, 2019 Unfortunately no experience with RFB Rigid Tubing Finishing Bit. Would you be able to provide any image of scuffed tubing? Have you tried to use less force or lower RPM? Link to comment Share on other sites More sharing options...
Gstro19 Posted July 22, 2019 Share Posted July 22, 2019 I haven't used it on the corsair tubing but I did use it a lot on some 16mm. On mine, the bearing didn't make a tight connection inside the tube so getting the tube flat was kind of a pain. It didn't really scuff the tubing up other than the very end where it chamfered it Link to comment Share on other sites More sharing options...
BlaiseP Posted July 22, 2019 Share Posted July 22, 2019 I have the 10/12mm PrimoChill finishing bit and it works extremely well albeit I'm using EKWB PETG tubing. Link to comment Share on other sites More sharing options...
Recommended Posts