Hej, I have a LL120 fan which I would like to connect directly to my motherboard. My mother board has 2 types of connectors (both 2 times):
3 pins addressable LED (5V) 4 pins 5050 RGB LED strip headers (12V)
Because the manual of LL120 stated that it needs 12volt and it is 4 wires, I connected it to the 4 pins header. But I do not get any light out of it. Except when I connect the header while running.... :bigeyes: But it is not configurable anyhow with RGB fusion (beside I would like to have my case closed whil running and not putting the cable each time on the header after starting...).
I tried also the 3 pin header, but that did not gave me a show either.
I was in the understanding that the fan could be connected directly to my motherboard without any other device in between. Is my understanding wrong or do I make a mistake?