Yellowbeard Posted May 6, 2013 Share Posted May 6, 2013 (edited) Corsair proudly brings you the Corsair SSD Toolbox. Please read the blog post before using the toolbox. Please note: You need to be in AHCI mode to update your firmware. Download the Corsair SSD Toolbox HERE. The latest version is 1.2.5.7 as of August 23, 2019. Below are the drive families that Toolbox supports as of today: - Force 3 - Force GT - Force GS - Force MP M.2 NVMe - Neutron - Neutron GTX - Nova2 (SF based only) - Accelerator Please note that we currently do not support upgrading old 1.3.x FW to 5.0x FW on Sandforce based drives. Users of 1.3.x firmwares will still need to update to 5.xx firmwares using the Sandforce based FW update process found in the SSD Firmware Update section. Once a user has updated to any version of 5.0x, they can then use the toolbox to upgrade to the latest FW (currently it is 5.05A). We are working on this, but it will be the next release before we can have it implemented (target release TBD). We are working on adding other (legacy) drive families, and as the support becomes available we will let you know. The Corsair SSD Toolbox will run on: •XP SP3 (32-bit)...(64-bit version not supported) •Vista 32-bit w/ latest SP (all functions) •Vista 64-bit w/ latest SP (all functions) •Win 7 32-bit w/ latest SP (all functions) •Win 7 64-bit w/ latest SP (all functions) •Win 8 32-bit (TRIM is not supported, all others functions are) •Win 8 64-bit (TRIM is not supported, all others functions are) •Win 10 32-bit (TRIM is not supported, all others functions are) •Win 10 64-bit (TRIM is not supported, all others functions are) Edited August 23, 2019 by Corsair Kevin Link to comment Share on other sites More sharing options...
Recommended Posts