sheldonjbraid

Thank you so much! Greatly appreciated.

Hello all, Does anyone know how I may go about ordering a replacement temperature sensor probe leads for Commander Pro? I accidently cut the end of one off. Thanks in advance for any help.

Thank you so much. I do prefer low fan speeds, so I will give it a try.

Hello all, I recently installed a Corsair Hydro Series, H60 2018 (CW-9060036-WW), 120mm Radiator, Single 120mm PWM Fan to cool my CPU. Corsair recommended to install the single fan as an air intake, which I did. I have enough room in my case to install another fan on the back side of the radiator and make the radiator fan set up a push/pull configuration. Will there be enough noticeable cooling improvement to make this worth doing? If so, what is the better set up - push/pull intake into the case or push/pull exhaust out of the case? Any advise greatly appreciated.

Thank you so much for the info. Greatly appreciated.

Okay, thank you for the response.

Hello all, I am seeking advice on using the Commander Pro to regulate my CPU Temperature. I am using a Corsair H60 liquid cooler. The CPU Pump Tach cable is plugged into the CPU_Fan header on the motherboard, and the radiator fan is plugged into the four pin Sys_Fan1 header on the motherboard. So right now the BIOS is regulating the radiator fan, and keeping the CPU at a fairly constant 37-40C. I am thinking that the ICUE Software with Commander Pro would allow me to keep that temperature lower. I don't do any gaming. This computer has 6 case fans (which includes the radiator fan), power supply fan, and Graphics card fan. Any advice will be sincerely appreciated.