I put in a support ticket 4 and 5 days ago, and i have not recieved a response of any kind and didnt get a email with a ticket number or any info when i put it in. ( i put it in with the digital assistant )
Problem 1 included in ticket ( for the xd5 problem )I bought a bunch of hydro x gear & my Xd5 wont allow me to go over 156 rpm. I tried multiple headers. I have it set up right. port 6 on Commander pro, set to 4 pin, devices set to my xd5 and xc7 Rgb lights work fine.
WHne io first installed them I was seeing 0 rpm and it would toggle to 5-300 rpm ( setting to fixed did nothing ) So after waiting 5 days now .. I took the system apart and tried the Xd5 with just a RAD in a closed loop, It went fast. So i assumed it was my loop design. I put it back with just 1 rad and cpu by themself. It ran good So i put the system all back togheter to see Icue status.
It showed 156 rpm it goes down, but not up even if i set a fixed pm the pump does not go faster. I did not hot swap the header on 6. From posts i have seen on the forums over these dayts I saw multipple people had this issue and had to RMA. But i cant get ahold of support. I dont know if my ticket didnt go through or what is going on. So i figured I would give the forums a try. Currently the temp of the xd5 is at 30c-35c idle Cpu goes 40-60 Idle .
Side Problem 2 NOT Included in ticket. - When i set my fans for ( hydro x fans) only 1 will spin, if i set my 2nd set for the 2nd rad the rpms go to 0. I dont know what is going on , but i assume that you can use more than 1 set. at a time for multiple rads . I tired setting it to 4 pin as well ( all of my fans are the same ) Sp rgb Elite
Side Problem 3 NOT Included in ticket. - the xc7 . I have it set up properly with input and output flow. But When i look in the block I can see the micro bubbles go around the jet plate and not through it. When i first installed it I saw the bubbles in the middle of the jet plate. But now they dont and just go around. ( i am guessing that is one reason my Cpu temp is high IDK? )
I assumed it got plugged up, So i took the xc7 out of the loop and ran distilled through the outflow port hoping that if there was anything in the fins it would flush it out ,, but nope. I also flushed all rads and tubing with the xd5 ( not connected to Commander ) to see if i left somethiung in the loop . I used a mesh strainer to catch the water when i drained each part. Nothing was in it. I did see soem black / brown specs in the tubing . I replaced all tubing and reset up the loop. But with the combination of all these issues. It does nothing.
Any help would be gratley appeciated