PeAkPinnacle

Hi Zotty, Thanks for all your feedback in this thread. I may have missed a post on this. Sorry if I am asking a question already asked. Below is the hardware I am wanting to purchase, but want to make sure there is no conflict or perhaps if I can do this a better way? 1) Corsair Obsidian 500D RGB (3 LL120mm fans) 2) Corsair Hydro Series H100i RGB Platinum 240mm (2 ML120mm fans) 3) Corsair QL120 ARGB 120mm 3 Pack with Lighting Node 4) Corsair Vengeance RGB Pro 32GB (4x8GB) I am wanting to install the H110i in the front of the case (radiator hoses at the top of the case), in a push/pull setup - using the top 2 LL120 fans at the front of the case to push the air into the H100i and use the 2 ML120's attached to the radiator to pull. The bottom of the front 3 fans will still be an intake, and used to move the heat pushed out from the GPU. The 3 QL120's I am wanting to use as exhausts by putting 2 up the top & 1 at the top/rear of the case. Is there a way to get the radiator ML120's and the Vengeance RGB Pro to synchronise with the other case fans? Should I change the orientation of the radiator? Will I need to purchase any additional brackets & if so, what do you recommend? Do I need to purchase anything else to get this working? Any other input/suggestions are welcomed. Kind Regards, Peak