Hi Zotty,
Thanks for all your feedback in this thread. I may have missed a post on this. Sorry if I am asking a question already asked.
Below is the hardware I am wanting to purchase, but want to make sure there is no conflict or perhaps if I can do this a better way?
1) Corsair Obsidian 500D RGB (3 LL120mm fans)
2) Corsair Hydro Series H100i RGB Platinum 240mm (2 ML120mm fans)
3) Corsair QL120 ARGB 120mm 3 Pack with Lighting Node
4) Corsair Vengeance RGB Pro 32GB (4x8GB)
I am wanting to install the H110i in the front of the case (radiator hoses at the top of the case), in a push/pull setup - using the top 2 LL120 fans at the front of the case to push the air into the H100i and use the 2 ML120's attached to the radiator to pull.
The bottom of the front 3 fans will still be an intake, and used to move the heat pushed out from the GPU.
The 3 QL120's I am wanting to use as exhausts by putting 2 up the top & 1 at the top/rear of the case.
Is there a way to get the radiator ML120's and the Vengeance RGB Pro to synchronise with the other case fans?
Should I change the orientation of the radiator?
Will I need to purchase any additional brackets & if so, what do you recommend?
Do I need to purchase anything else to get this working?
Any other input/suggestions are welcomed.
Kind Regards,
Peak