Tiger33 Posted September 22, 2010 Share Posted September 22, 2010 Hi all. in CPUZ I see the memory listed as Dual Channel DRAM FREQUENCY 401mhz FSB:DRAM: CPU/8 then 5-5-5-18 and trc is 22 the volts for the ram are at 1.8. Now my question is - - are the settings right (i have everything on auto by the way - not manuall configured in the bios) The reason i'm asking is because i've been looking through the forums and it seems the settings for this memory module that people are using are different and also the settings beign recommended are different for example http://forum.corsair.com/forums/showthread.php?t=53297 on the above post it is suggested that the memory is run at DDR Volatge: 1.9v DDR Frequency: 800MHZ TCL: 5 TRCD: 5 TRP: 5 TRAs; 12 Command RAte: 2T then here http://forum.corsair.com/forums/showthread.php?t=51537 it is suggested XM2S-6400---Cas 5-5-5-15 (no word on voltage though) What should i really be running the memory on this board at? Link to comment Share on other sites More sharing options...
Synthohol Posted September 23, 2010 Share Posted September 23, 2010 actually, everything looks just fine especially with 4 sticks!! if you are stable, you are good to go!! Link to comment Share on other sites More sharing options...
Tiger33 Posted September 23, 2010 Author Share Posted September 23, 2010 I was just a bit worried that maybe i've been running with the wrong settings.. so wondered if i needed to enter the settings manually then noticed the different settigns others were using. was concerned as i was thinking of uping my processor too Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.