chris82079 Posted June 15, 2022 Share Posted June 15, 2022 XD5 pump, Commander core xt. Icue doesn't see the pump. I went in and setup the pump in the 3 pin. I've been searching and have hit a wall. any suggestions would be welcome. Thank you! Link to comment Share on other sites More sharing options...
Latharion Posted June 15, 2022 Share Posted June 15, 2022 The Commander Core XT port that the pump is attached to needs to be set to "4-pin". If it is not automatically detected (a very common issue) then it can be set up manually. It is common to set the pump to a fixed RPM and then leave it. Link to comment Share on other sites More sharing options...
LeDoyen Posted June 15, 2022 Share Posted June 15, 2022 What are you trying to do? get PWM speed control or set up the pump RGB? Link to comment Share on other sites More sharing options...
chris82079 Posted June 15, 2022 Author Share Posted June 15, 2022 I tried to set 4pin manually and also tried automatic. whenever i get to the hydro x setup wizard and choose xd5 it only gives me the option for the 4 fans i have installed on ports 2,3,4,5. I've tried xd5 in 6 and 1 Link to comment Share on other sites More sharing options...
chris82079 Posted June 15, 2022 Author Share Posted June 15, 2022 (edited) speed pump controller, rgb works fine after setting up in the 3 pin settings Edited June 15, 2022 by chris82079 Link to comment Share on other sites More sharing options...
Latharion Posted June 15, 2022 Share Posted June 15, 2022 A performance profile can be created manually instead of using the wizard. The wizard simply generates a setting that can be used to control the pump and fans that is set to automatically control the speeds based on the temp sensor in the XD5 pump. The same settings can be created manually if desired. Link to comment Share on other sites More sharing options...
chris82079 Posted June 15, 2022 Author Share Posted June 15, 2022 21 minutes ago, Latharion said: A performance profile can be created manually instead of using the wizard. The wizard simply generates a setting that can be used to control the pump and fans that is set to automatically control the speeds based on the temp sensor in the XD5 pump. The same settings can be created manually if desired. that's good to know. Thank you! It's not affecting the system performance at all. just ran prime95 for 30+ minutes. Barely touched 80 a couple times. stayed in the high 60's, low 70's mostly Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now