schmak01 Posted May 11, 2020 Share Posted May 11, 2020 (edited) So I am having problems with only 1 fan. When I set it to 0% or 0 RPM it goes to 100%. If I switch another fan to that port, it does the same thing. Looks to be an issue with the commander pro? If I try changing the sensor to anything other than the Radiator coolant temp (H115i Plat), it fires to 100% on that #1 fan port. It also thinks for some reason I have hydro X connected but I do not. https://i.imgur.com/12PTKFU.png Edited May 11, 2020 by schmak01 Link to comment Share on other sites More sharing options...
c-attack Posted May 11, 2020 Share Posted May 11, 2020 In the iCUE settings -> Commander Pro, try setting fan header #1 to "4 pin" instead of Auto. Sometimes the auto detection doesn't take. If you have all PWM fans, this skips the unnecessary fan test at power on since it already knows the fan is PWM. Link to comment Share on other sites More sharing options...
schmak01 Posted May 11, 2020 Author Share Posted May 11, 2020 In the iCUE settings -> Commander Pro, try setting fan header #1 to "4 pin" instead of Auto. Sometimes the auto detection doesn't take. If you have all PWM fans, this skips the unnecessary fan test at power on since it already knows the fan is PWM. This did it, but I had to reboot. I have all PWM fans so I just set them all this way. Thanks! Link to comment Share on other sites More sharing options...
Recommended Posts