CMBoss Posted July 22, 2019 Share Posted July 22, 2019 (edited) My 180 has an issue, anyone know how to resolve this when I switched it on for the first time , it came on and I went straight to bios , while just looking at the screen , the pc rebooted and started again , I went back to bios and it did reboot yet again but this time flashing red on the left pane led strip I checked online and found it had to do with heat , so I cross checked my fan and found out the fan wasn’t spinning again and I was sure it spun when I powered it on the first time So I proceeded to check the cable , all good , removed and put them back same issue. After some back and forth , I decided to plug the fan directly to the mobo header and remove the single pin plug coming from the cpu pump into that header The fan worked I managed to finish setup and enter into the icue software and it said Fan 0rpm , cpu, GpU pump and coolant all spinning 1922,1963 rpm and 27 and 22.6 respectively Does this mean the pump is bad, since I can’t control the fans thru the single pin ? Also the GpU fans don’t show any rpm on icue or any other monitoring software Do they start at a particular temperature or are they also controlled by the single pin removed from the fan header ? Please advice Edited July 22, 2019 by CMBoss Link to comment Share on other sites More sharing options...
Corsair Employee Corsair StormShadow Posted July 22, 2019 Corsair Employee Share Posted July 22, 2019 replied in PM. Do give us a call if you have other issues. Link to comment Share on other sites More sharing options...
CMBoss Posted July 22, 2019 Author Share Posted July 22, 2019 replied in PM. Do give us a call if you have other issues. PM Responded to, thank you Link to comment Share on other sites More sharing options...
Recommended Posts