oz1sqt Posted August 9, 2018 Share Posted August 9, 2018 After updating to iCUE 3.5.111 my Windows 10 64Bit dos not recognize the driver for H110i V2 1 minute before the update I had changed the pump speed in iCUE then clicked to se if there ware any updates Link to comment Share on other sites More sharing options...
Carbonic Posted August 9, 2018 Share Posted August 9, 2018 Tried rebooting? Link to comment Share on other sites More sharing options...
oz1sqt Posted August 9, 2018 Author Share Posted August 9, 2018 I tried again, and now is it recognized, but now i don't trust the readout of the RPM off the pump, its showing 1920 RPM on quiet mode and 2981 RPM on Extream mode. I can't set it to balanced mode My AIDA64 says 953 RPM on quiet mode and 1452 RPM on Extream mode Link to comment Share on other sites More sharing options...
DevBiker Posted August 9, 2018 Share Posted August 9, 2018 First, two software applications shouldn't be accessing the device at the same time. This won't work. And it can crash the driver. Don't do it. If you are reading the CPU_FAN reading from AIDA as the pump speed, the pump reports about 1/2 of it's actual speed as the fan speed. Second, the pump readings are correct and that pump only supports two speeds - Quiet and Extreme. So ... what you are describing sounds perfectly normal. Link to comment Share on other sites More sharing options...
oz1sqt Posted August 9, 2018 Author Share Posted August 9, 2018 Strange it did work before the update I would prefer to use the Corsair sidebar over the AIDA64 if I could move the panel to another screen Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.