knacker40 Posted October 16, 2019 Share Posted October 16, 2019 any ideas with this. Installed said above H150i onto 8700k on Z390 board but the block is very loose even after tightening the thumbscrews. Tried adding washers on back and front and still the same- temps immediately ramp up to 100c on non overclock chip Am I missing something here as would like to have complete corsair stuff as haviing to use an NZXT aio currently and is a bit of a problem with the rgb lighting Link to comment Share on other sites More sharing options...
Corsair Mike Posted October 16, 2019 Share Posted October 16, 2019 Hi Knacker40, sorry to hear about the trouble you are having with your cooler. The cooler should fit snugly and be difficult to move. I would double check that the stand offs that come with the cooler are screwed down all of the way and that the back plate is lined up with the holes properly. If all of those things are good I would reach out to customer support at support.corsair.com. Link to comment Share on other sites More sharing options...
Recommended Posts