jfrob Posted December 7, 2019 Share Posted December 7, 2019 Just finished installing liquid cooling using the Corsair Hydro X CPU block and pump/res combo using 360mm rad. It seems to be working fine but I am unable to control my fans thru the Hydro X Series Fans selection in iCUE. When I select this setting a message is displayed indicating the Pump/Reservoir Combo temperature sensor needs to be plugged into TEMP 1, which it is. I tried all 4 temp inputs but no change. I am getting a temperature reading from the sensor. Any ideas what is going on? Link to comment Share on other sites More sharing options...
jfrob Posted December 7, 2019 Author Share Posted December 7, 2019 Here is an image of my iCUE with Hydro X Series Fans selected. Link to comment Share on other sites More sharing options...
DevBiker Posted December 7, 2019 Share Posted December 7, 2019 Hello ... That's a set fan curve so you can't configure it. The values for the curves can be found in the HydroX FAQ: https://forum.corsair.com/v3/showthread.php?t=188181. Link to comment Share on other sites More sharing options...
jfrob Posted December 7, 2019 Author Share Posted December 7, 2019 Hello ... That's a set fan curve so you can't configure it. The values for the curves can be found in the HydroX FAQ: https://forum.corsair.com/v3/showthread.php?t=188181. Thanks for the info but how does one set manual curves? Link to comment Share on other sites More sharing options...
jfrob Posted December 7, 2019 Author Share Posted December 7, 2019 Never mind I figured it out. Link to comment Share on other sites More sharing options...
Recommended Posts