XRayAdamo Posted October 7, 2018 Share Posted October 7, 2018 Since last update I have strange behavior of iCue with my h100i AIO. Just turned on PC and FANs at 100% Anyway to fix it? I had to create special profile and attach it to the CPU temp to work properly. But it was ok for a long time before Link to comment Share on other sites More sharing options...
c-attack Posted October 7, 2018 Share Posted October 7, 2018 We can't see your curve or the control variable in that picture, but if you set the control to CPU temperature, that is surely going to cause erratic behavior. Link to comment Share on other sites More sharing options...
XRayAdamo Posted October 8, 2018 Author Share Posted October 8, 2018 Probably my description was a little confusing. The problem with default quite profile, not with my own profile. Link to comment Share on other sites More sharing options...
BlaiseP Posted October 10, 2018 Share Posted October 10, 2018 Sorry to chime in late - this can happen if the CLC fan(s) aren't seeing the PWM signal (after all, this is what determines what speed the fans will run at). Try reseating the fan connections. Link to comment Share on other sites More sharing options...
dwjp90 Posted October 10, 2018 Share Posted October 10, 2018 You are using 4pin fans correct? Link to comment Share on other sites More sharing options...
c-attack Posted October 10, 2018 Share Posted October 10, 2018 You can try and re-connect the pins on the splitter (or even switch them) and this sometimes helps. Make sure the control variable under the graph is set to H100i GT/V2 temp and not something like CPU package temp. Coolant scale runs about 20-40C, so changing the control to CPU temp (30-80C+) will light you up in a hurry. You may also want to create a custom curve, if for nothing else to demonstrate there is some sort of control. Fixed % and Fixed RPM are both in the custom "Cooling Mode" created when you hit the +. While you are at it, set the points to where you want them to be. No reason to rely on some arbitrary fan control points not specifically designed for your hardware, environment, and preferences. Link to comment Share on other sites More sharing options...
Inheritance Posted October 11, 2018 Share Posted October 11, 2018 Hum, Im seeing this issue with my unit too. If you disconnect the USB cable from the pump does it still spin up to max RPM for you? Does the device still show up in iCUE even if the USB cable is removed? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.