i_max2k2 Posted April 10, 2010 Share Posted April 10, 2010 I have been using my P256 since January now, and I have been very please with its performance, even till this point I haven't felt any performance degradation, however I had ran some ATTO disk benchmarks shortly after I installed my drive and I ran another one today, the screenshot from the older and most recent run are attached. I'm using this ssd on an Alienware m15x, with Windows 7 ultimate, with TRIM enabled. I have followed the tips and tricks guide here to the maximum I can make it work with my system. Now very honestly, the performance lapse isn't much but I was wondering what I could do to make the performance similar to how it came as, the hdd is 70% filled up. Any help is appreciated. I noticed I could leave it powered on for an hour, but I have to login to windows, is that supposed to be done in order for that to work? Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 13, 2010 Corsair Employee Share Posted April 13, 2010 Do you have the latest Intel Storage drivers installed assuming that that system is Intel based? Link to comment Share on other sites More sharing options...
i_max2k2 Posted April 14, 2010 Author Share Posted April 14, 2010 I think I have intel storage driver, how could I figure, what version they are? and where could I get the latest ones from. Thanks! Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 14, 2010 Corsair Employee Share Posted April 14, 2010 You would need to check with Intel for the latest version that is available and then with the MB Maker to see what version they have available. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.