yogalD Posted October 2, 2014 Share Posted October 2, 2014 So the front panel on the Graphite 230T is held into the case by 3 tabs on each side, I can release 5 of them but the last one, at the top right of the case (when viewed from the front) I cannot release. Is there a secret to releasing it? Link to comment Share on other sites More sharing options...
yogalD Posted October 25, 2014 Author Share Posted October 25, 2014 Bump (10char) Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted October 27, 2014 Corsair Employee Share Posted October 27, 2014 There shouldn't be. Just bend it out the way you did with the other five. Link to comment Share on other sites More sharing options...
yogalD Posted November 4, 2014 Author Share Posted November 4, 2014 The problem is that tab in particular doesn't bend out far enough to release no matter hard I pull on it Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted November 4, 2014 Corsair Employee Share Posted November 4, 2014 That is unusual. Honestly I wouldn't worry about potentially breaking the tab, just bend the sucker out. Link to comment Share on other sites More sharing options...
yogalD Posted November 5, 2014 Author Share Posted November 5, 2014 Alrighty... and if it goes then it doesn't really matter does it, it won't affect anything is that right? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted November 5, 2014 Corsair Employee Share Posted November 5, 2014 That's right. Even if that tab breaks there's still the other five holding the fascia in place. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.