SkyfaII Posted November 24, 2018 Share Posted November 24, 2018 I purchased the LNP yesterday and it worked just fine and today I purchased the HD120 Triple pack and when I plugged everything in and powered the PC on the fans were fine but all 4 led strips were flickering... I have no clue what to do anymore. I've tried reinstalling all firmware's, unplugging and replugging cables to no avail... I'm hoping that it's just a software issue that can be resolved. [ame= ] [/ame] Link to comment Share on other sites More sharing options...
DevBiker Posted November 24, 2018 Share Posted November 24, 2018 That looks like a power issue. Do you have any adapters or splitters in the mix? Link to comment Share on other sites More sharing options...
SkyfaII Posted November 24, 2018 Author Share Posted November 24, 2018 That looks like a power issue. Do you have any adapters or splitters in the mix? Nope! everything is connected directly Link to comment Share on other sites More sharing options...
DevBiker Posted November 24, 2018 Share Posted November 24, 2018 Have you tried reordering the strips in the line? Maybe one strip at a time? It really does look like it's not getting the +5V that it needs. Did you connect it with the 3-wire line or the 2-wire? Link to comment Share on other sites More sharing options...
SkyfaII Posted November 24, 2018 Author Share Posted November 24, 2018 Have you tried reordering the strips in the line? Maybe one strip at a time? It really does look like it's not getting the +5V that it needs. Did you connect it with the 3-wire line or the 2-wire? I’ve tried reordering the strips 1 by 1 and it’s always the same problem. The strips are connected directly to the LNP in port 1. Link to comment Share on other sites More sharing options...
SkyfaII Posted November 24, 2018 Author Share Posted November 24, 2018 Have you tried reordering the strips in the line? Maybe one strip at a time? It really does look like it's not getting the +5V that it needs. Did you connect it with the 3-wire line or the 2-wire? And the only color that works is red Link to comment Share on other sites More sharing options...
SkyfaII Posted November 24, 2018 Author Share Posted November 24, 2018 So... I ended up just replacing the other LNP and all is well now. I guess it was defective. Link to comment Share on other sites More sharing options...
DevBiker Posted November 25, 2018 Share Posted November 25, 2018 So... I ended up just replacing the other LNP and all is well now. I guess it was defective. Likely it wasn't delivering 5V on the power line - the fuse got blown. I've seen the exact behavior that you described on a test NoPro that I have with one blown fuse. The other channel is fine (they are fused separately). I wonder if you could have swapped channels - the fan hub only receives the data signal; it has its own power. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.