howardpm Posted December 2, 2010 Share Posted December 2, 2010 So I was all done with my new machine, powered it up and nothing happened, after checking a bunch of stuff I figured I had to plug in the extra 12V power cable. Sadly this cable doesn't seem long enough to go out one of the gromets and reach around to the top, so now my semi nice clean inside now has 1 large wire reaching all the way from the bottom to the top. (see picture). Is there any easy way to thread this cable so it reaches the 12V in the top corner of the board, with the p/s on the bottom of the case? P.S. Any tips on running the PCI Express cables would be nice, those cables are to long and so much extra slack. Link to comment Share on other sites More sharing options...
Yellowbeard Posted December 2, 2010 Share Posted December 2, 2010 I put an AX850 into that case last week. The cable is long enough. Just run it out of the grommet closest to the PSU and come back in via that hole at the top left corner. Link to comment Share on other sites More sharing options...
Carlos68 Posted December 2, 2010 Share Posted December 2, 2010 Yeah i've got the same case and PSU and the cable is plenty long enough to reach around the back of the MB tray ? Link to comment Share on other sites More sharing options...
howardpm Posted December 3, 2010 Author Share Posted December 3, 2010 Thanks, I got it, I had to run the cable through a partially covered grommet and then I was able to make it reach. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.