bazcb Posted September 11, 2018 Share Posted September 11, 2018 Hey, I have a h100i and I’m currently upgrading to a z370 board, the back plate fits into the slots, but doesn’t tighten up there’s too much slack. How can I pack this out for it to fit and have a save fitting for block and cpu Link to comment Share on other sites More sharing options...
c-attack Posted September 11, 2018 Share Posted September 11, 2018 The unit is not supposed to be tight until you fasten all of the mounting posts/screws. You do not need to grind those into the motherboard. Hand tightening or a 1/4 turn past with a screw driver is plenty. Is that it? Or something else? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.