Lakristomten Posted October 23, 2019 Share Posted October 23, 2019 9900k, liquid cooled RTX2080TI, liquid cooled 32GB 2666 DDR4 480gb M.2 z370i mini-ITX SF600, 80 plus Gold W10 BIOS: 2.QJ 05/22/2019 Anyone OC this prebuild, what is your settings? Link to comment Share on other sites More sharing options...
Lakristomten Posted October 23, 2019 Author Share Posted October 23, 2019 (edited) Hello Searching OC settings for the i160 built. I've used a general MSI guide and followed up a CPU bench with 3dmarks TIMESPY. However I am not liking the result with manually OC. These are the following steps I've taken from a MSI guide on youtube. 1. OC Explore Mode Set to [Expert] CPU Ratio Apply Mode [All Core] CPU Ratio 50 CPU Ratio Mode [Fixed Mode] All Run at 5Ghz no matter what for system stability CPU Ratio Offset When Running AVX [-3] Tip from the guide 2. DigitALL Power> CPU Loadline Calibration Control [Mode 4] Perfect no matter what load see diagram rightside in bios 3. CPU Core Voltage 1.320 CPU SA Voltage 1.200 CPU IO Voltage 1.200 DRAM Voltage 1.360 4. Overclocking\CPU Features Intel C-State [Disable] (Power saving mode) Alternative that has been applied and followed CPU Ring Ratio 47 3 under CPU Core Voltage Mode "override och auto (same?) - I haven't set a throttling temperature - should I? My temperature with the fan curve is a bit weird, the CORE0 is higher than the others and overallt the temps jumps a bit. Looking at the HW monitor the voltage of i9900k jumps between 1.215(4)-1.3. - 3DMARKSCORE TIMESPY CUSTOM -GPU -DEMO Results: 1. STOCK 3DMark CPU test score 9 057 (3.6Ghz) 9169 with XMP enable 2. Game Boost 3DMark CPU test score 10 426 (4.8Ghz / 4000Ghz in the end) 10 242 with XMP enable 3. Enhanced Turbo + XMP CPU-Z (5GHZ Singel thread 582.3 Multiply thread5050.1 3DMark CPU test score 10 575 (5GHZ dropped too 4.4 then back up too 5GHZ) 4. 5Ghz Overclock + XMP CPU-Z (5GHZ ST 587.9 MT 5242.3/ 3DMark CPU test score 8 784 (It went down to lower rates aswell) I am looking for a 5-5.2 overclock if possible. Any suggestions, guidelines is appreciated. Also something I noticed is with the XMP enable, my stats at CPU-Z memory I dont think it works, dont know what value I should see but should it not be, show more(doubble) than 1333 in DRAM freq? /Cheers Edited October 23, 2019 by Lakristomten Link to comment Share on other sites More sharing options...
Recommended Posts