Not a Number Posted July 15, 2020 Share Posted July 15, 2020 According to SSD Tool firmware release ECPM13.2 is available for my MP510. I can't find anything about this version. Anybody know what the update addresses? Also is this a "destructive" upgrade from ECPM13.1 and I would have to backup and restore all my data? Thanks Link to comment Share on other sites More sharing options...
Not a Number Posted August 5, 2020 Author Share Posted August 5, 2020 Does anybody have the change log for this update? Link to comment Share on other sites More sharing options...
Not a Number Posted September 20, 2020 Author Share Posted September 20, 2020 Anybody? There seems to be no info available on this update. Link to comment Share on other sites More sharing options...
Not a Number Posted October 10, 2020 Author Share Posted October 10, 2020 Since no one here would answer my question I used the support contact form from the Corsair support page. Here's the reply: Regarding your question: "What changes are in this version over 13.1?" If the SSD's write and read speed were too slow, the update fixes it. The speed update is the main difference. There is not detailed documentation about the FW differences, but the recommendation is that t can be updated in case of presenting unusual slow speeds. Thank you for your question. Have a good day! Best Regards, Carla Campos Thank you for choosing Corsair. Link to comment Share on other sites More sharing options...
Brat Posted November 6, 2020 Share Posted November 6, 2020 Is there anyone who has tried this and know if it works? Or has it bricked every computer that installed it and that is the reason for no reactions? I feel I will wait before I use it for my MP600 500GB, it is having writespeeds of around 1500Mb/sec at 61% filled, at 81% it was down at 500Mb/sec compared to the initial 4000Mb/sec. Link to comment Share on other sites More sharing options...
Not a Number Posted December 22, 2020 Author Share Posted December 22, 2020 So now there is a ECFM13.3 available. Again no release notes. The SSD Toolbox should have a "What's New" link whenever there is an update available. BTW: My MP510 is 480GB Link to comment Share on other sites More sharing options...
JohnWayne78 Posted March 9, 2021 Share Posted March 9, 2021 how to get 13.x? SSD Toolbox shows only 12.3 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now