Hi. After years of using Link I finally switched to iCue on two of my computers. Now there is a major problem which I never saw with Link, and that is with remote access (Windows RDP). I can see iCue on the remote computer, but iCue does not see its own Corsair devices (neither H115, nor Commander Pro and the fans attached to it). So I see no temps or fan speeds. iCue only shows me the non-Corsair devices like CPU, mainboard, DRAM, graphics card. In non-remote access I can see everything. And what makes it even worse: When you RDP into a computer, the currently signed in user is signed off and the system stays in this state until you sign in again, either directly or remotely. But when iCue cannot see (and control) the pump and fans while a remote user is signed in, it most certainly cannot do so while no user is signed in. Again, this has never ever been a problem with Link. And to clarify: To enter this problem, you do not even have to open iCue while remotely accessing the distant computer. Did you ever run into this problem? Do you have any suggestions for me?