Dirjampa

Hello again, Slight change to the above. The radiator fan is spinning at 1673rpm and that's at 100%. (It was the pump that was spinning at 4K) My earlier numbers were wrong, and the speed of the radiator fan is controllable. But its still not cooling my proc down though 😞 Thanks folks. D

Hi Guys, I've just installed a white H60 into my Dell Aurora R6, replacing the stock cooler, but its not performing... My processor has been running at increasingly crazy temps while rendering relatively simple jobs, sending my fans into orbit. My work around was to run the proc at 85%, which kept the lid on, but this only just kept us out of the 90deg zone. It also meant my rendering was slower than it could be. So today I unplugged the Alien cooler and replaced it with the H60. Apart from the fact that the new radiator is about 1mm too long to fit in the radiator holder (It is now sitting outside and on top of the tower which wasn't part of the plan), the fitting went well. I didn't need to install the back plate and the supplied extensions provide a snug fit, so it all looked good. But its not cooling the proc....... Sata is connected, pump tach is connected, fan is connected and the proc is back up at 100% perf. Although the alien says the fan is spinning at roughly 4400 RPM, im idling at 50/60deg and exporting just now from Adobe Premiere Pro had my proc up at 99deg. Questions: 1 - Am I right in thinking the H60 fan only spins at 1 speed, hence the 3 pin config. (I have found no way of controlling the speed, but it seems to be set at the top speed of the stock fan I've just removed.) 2 - Any ideas why its not reacting to the rising temp of the Proc? There is lovely cool air running through the radiator, and the cooler is seated snugly, but these temps are not far off what I see with no cooler on the proc at at all. Thanks in advance folks. D