sheldonjbraid
-
Posts
7 -
Joined
Content Type
Forums
Gallery
Release Notes
Corsair Blog
Store
Profiles
Posts posted by sheldonjbraid
-
-
Hello all,
Does anyone know how I may go about ordering a replacement temperature sensor probe leads for Commander Pro? I accidently cut the end of one off. Thanks in advance for any help.
-
Thank you so much. I do prefer low fan speeds, so I will give it a try.
-
Hello all,
I recently installed a Corsair Hydro Series, H60 2018 (CW-9060036-WW), 120mm Radiator, Single 120mm PWM Fan to cool my CPU. Corsair recommended to install the single fan as an air intake, which I did.
I have enough room in my case to install another fan on the back side of the radiator and make the radiator fan set up a push/pull configuration.
Will there be enough noticeable cooling improvement to make this worth doing? If so, what is the better set up - push/pull intake into the case or push/pull exhaust out of the case? Any advise greatly appreciated.
-
Thank you so much for the info. Greatly appreciated.
-
Okay, thank you for the response.
-
Hello all,
I am seeking advice on using the Commander Pro to regulate my CPU Temperature. I am using a Corsair H60 liquid cooler. The CPU Pump Tach cable is plugged into the CPU_Fan header on the motherboard, and the radiator fan is plugged into the four pin Sys_Fan1 header on the motherboard. So right now the BIOS is regulating the radiator fan, and keeping the CPU at a fairly constant 37-40C. I am thinking that the ICUE Software with Commander Pro would allow me to keep that temperature lower. I don't do any gaming. This computer has 6 case fans (which includes the radiator fan), power supply fan, and Graphics card fan. Any advice will be sincerely appreciated.
Temperature Sensor Leads for Commander Pro
in iCUE Software Troubleshooting
Posted